Hasnul, Muhammad Raihan and Prof. Dr. Ir. Rini Nur Hasanah, S.T., Msc. IPU. ASEAN Eng., SMIE and Ir. Lunde Ardhenta, S.T., M.Sc. (2023) Rancang Bangun Pendingin Pada Sistem Maximum Power Point Tracking (MPPT) Perturb & observe,. Sarjana thesis, Universitas Brawijaya.
Abstract
Masalah utama penggunaan sistem Photovoltaic adalah rendahnya efisiensi energi listrik yang dihasilkan, terutama dalam kasus intensitas radiasi matahari yang rendah dan perubahan suhu. Di antara berbagai perubahan intensitas radiasi dan suhu, terdapat titik dimana PV akan menghasilkan energi tertinggi dengan efisiensi tertinggi. Titik ini disebut Maximum Power Point (MPP). Lokasi dari MPP tidak diketahui, sehingga dibutuhkan algoritma pelacakan atau biasa disebut dengan Maximum Power Point Tracking (MPPT) yang dapat digunakan untuk mencari titik ini untuk menghasilkan daya yang maksimal. Dalam sistem Photovoltaic, dibandingkan dengan tidak menggunakan MPPT, daya rata-rata yang dihasilkan oleh MPPT meningkat 16-43%. Pada penelitian ini digunakan MPPT perturb & observe (P&O). Peningkatan intensitas radiasi sebanding dengan besar daya keluarannya. Ketika intensitas radiasi tinggi, suhu juga meningkat. Ketika temperatur meningkat maka efisiensi dari Photovoltaic akan menurun. Oleh karena itu, temperatur permukaan PV harus dijaga pada temperatur tertentu agar modul PV tetap dapat bekerja pada MPP-nya. Dalam beberapa tahun terakhir banyak ditemukan penelitian mengenai bentuk bentuk peningkatan efesiensi panel surya dengan menjaga suhu permukaan panel suryanya. Terdapat empat kategori sistem pendingin berdasarkan jenis pendinginnya yaitu : air, udara, refrigerant dan heat pipe. Pada penelitian ini dirancanglah sistem pendingin yang menggunakan air. Berdasarkan hasil yang diperoleh dari pengujian sistem MPPT dengan sistem pendingin, untuk mendinginkan suhu panel surya dari 50,50C - 300C dibutuhkan waktu 9 menit 50 detik. Daya yang dihasilkan panel surya dengan sistem pendingin meningkat sebesar 8.748% dibandingkan tanpa sistem pendingin. Dapat disimpulkan bahwa semakin kecil suhu panel surya maka daya yang dihasilkan semakin besar atau hubungan antara suhu panel surya dan daya yang dihasilkan adalah berbanding terbalik.
English Abstract
The main problem with the use of Photovoltaic systems is the low efficiency of the generated electrical energy, especially in the case of low solar radiation intensity and temperature changes. Among the various changes in radiation intensity and temperature, there is a point where PV will produce the highest energy with the highest efficiency. This point is called the Maximum Power Point (MPP). The location of the MPP is unknown, so a tracking algorithm or commonly known as Maximum Power Point Tracking (MPPT) is needed which can be used to find this point to produce maximum power. In a Photovoltaic system, compared to not using MPPT, the average power generated by MPPT increases by 16-43%. In this study MPPT perturb & observe (P&O) was used. The increase in radiation intensity is proportional to the output power. When the radiation intensity is high, the temperature also increases. When the temperature increases, the efficiency of Photovoltaic will decrease. Therefore, the PV surface temperature must be maintained at a certain temperature so that the PV module can still work on its MPP. In recent years, many studies have been found regarding forms of increasing the efficiency of solar panels by maintaining the surface temperature of the solar panels. There are four categories of cooling systems based on the type of coolant, namely: water, air, refrigerant and heat pipe. In this study designed a cooling system that uses water. Based on the results obtained from testing the MPPT system with a cooling system, it takes 9 minutes 50 seconds to cool the solar panel temperature from 50.50C - 300C. The power generated by solar panels with a cooling system increases by 8,748% compared to without a cooling system. It can be concluded that the smaller the temperature of the solar panel, the greater the power generated or the relationship between the temperature of the solar panel and the power generated is inversely proportional.
Item Type: | Thesis (Sarjana) |
---|---|
Identification Number: | 0523070322 |
Uncontrolled Keywords: | Photovoltaic, MPPT, Perturb & observe, sistem pendingin. |
Subjects: | 600 Technology (Applied sciences) > 621 Applied physics > 621.3 Electrical, magnetic, optical, communications, computer engineering; electronics, lighting > 621.38 Electronics, communications engineering > 621.381 Electronics |
Divisions: | Fakultas Teknik > Teknik Elektro |
Depositing User: | Endang Susworini |
Date Deposited: | 05 Oct 2023 01:23 |
Last Modified: | 05 Oct 2023 01:23 |
URI: | http://repository.ub.ac.id/id/eprint/203519 |
![]() |
Text (DALAM MASA EMBARGO)
Muhammad Raihan Hasnul.pdf Restricted to Registered users only until 31 December 2025. Download (9MB) |
Actions (login required)
![]() |
View Item |